Remington 500V - Manual (Page 24)

24
106763
I. ASSEMBLING BARREL ASSEMBLY
1. Using moderate force, insert piston assembly into barrel (see Figure 23).
H. ATTACHING HANDLE PAD ASSEMBLY
1. Place handle pad assembly onto housing body and tighten screw with 3mm hex
wrench. Make sure rocker arm spring stays tight against the handle pad
assembly while tightening screw.
Tool Assembly (Cont.)
3mm Hex
Wrench
Figure 22 - Attaching Handle Pad Assembly
Handle Pad
Assembly
Figure 23 - Inserting Piston Assembly into Barrel
Piston
Assembly
Barrel
G. ATTACHING REAR PAD ASSEMBLY
1. Push the rear pad and power indicator assembly onto housing, aligning screws
with holes in housing.
2. Holding pressure on rear pad and indicator assembly, tighten screws with 3mm
hex wrench. Note: Rear pad and power indicator assembly is spring loaded.
Pressure should be kept on the assembly at all times while tightening screws
to avoid loosing parts.
Figure 21 - Attaching Rear Pad and Power Indicator Assembly
Rocker Arm
Spring
Screws
Rear Pad and Power
Indicator Assembly
Housing