Radio Shack PRO-2018 - Manual (Page 18)

S
earching
th
e
O
ne
T
ouc
h B
anks
18
2. Press ENT again to store the frequency. The channel
and frequency flash twice. If you want to cancel the
operation, press
TUNE/CLEAR instead of ENT . After
storing the frequency, the scanner continues to search
for frequencies.
±
5ECPPKPI"VJG"5VQTGF"%JCPPGNU
To set the scanner to continuously scan through all
channels with stored frequencies, repeatedly press
SCAN
until
I97D I97D I97D I97D
and H appear. The scanner rapidly scans until it
finds an active frequency.
If the scanner finds an active frequency, it stops and
displays that channel and frequency number, then it
automatically begins scanning again when the conversation
on that frequency ends unless delay is set for the channel
(see “Delay” on Page 20).
±
6WTPKPI"%JCPPGN/5VQTCIG"$CPMU"1HH"CPF"1P
Channel-storage banks (1-10) are on when they have a bar
underneath them and off when no bar appears underneath
them. To turn off a channel-storage bank, press the bank's
number key during scanning. The bar under the bank's
number disappears.
To turn on a channel-storage bank (1-10) during scanning,
press the bank's number key. A bar appears under the
bank's number.
±
If no transmission is found, the scanner continues to scan
through all selected banks.
/QPKVQTKPI"C"5VQTGF"%JCPPGN
You can continuously monitor a specific channel without
scanning. This is useful if you hear an emergency
transmission on a channel and do not want to miss any
details – even though there might be periods of silence – or
if you simply want to monitor that channel.
Follow these steps to manually select a channel.
1. Repeatedly press SCAN/MAN until
C7D C7D C7D C7D
appears.
2. Enter the channel number (1-200).
3. Press SCAN/MAN again.
±
"016'"
±
"
Scanning the Stored
Channels
• To reverse the scanning
direction, press
H or G .
• To set the scanner to remain on
the current channel for 2
seconds after the transmission
ends, see “Delay” on Page 20.
• To set the scanner to remain on
the current channel, even after
the transmission stops, press
SCAN/MAN at any time during
the transmission.
C7D C7D C7D C7D
appears
and
I97Dý I97Dý I97Dý I97Dý
disappears (see
“Monitoring a Stored Channel”
on Page 18).
• To lock out channels so the
scanner does not stop for a
transmission on those channels,
see “Locking Out Channels or
Frequencies” on Page 21.
Turning Channel-Storage
Banks Off and On
• The scanner does not scan any
of the channels within the banks
you have turned off.
• You cannot turn off all banks.
There must be at least one
active bank.
• You can manually select any
channel in a bank, even if the
bank is turned off.
• When you turn on a bank during
scanning, the scanner moves to
the selected bank and scans it.
20-424.fm Page 18 Monday, September 9, 2002 9:44 AM