Radio Shack PRO-2018 - Manual (Page 12)

Unders
tanding Banks
12
(ýC
Appears when you turn on the 2m sub-bank while searching
in the HAM bank.
-&9ýC
Appears when you turn on the 70cm sub-bank while
searching in the HAM bank.
70&'456#0&+0)"$#0-5
%JCPPGN"5VQTCIG"$CPMU
A bank is a storage area for a group of channels. Channels
are storage areas for frequencies. Whereas a channel can
only contain one frequency, a bank can hold numerous
channels.
±
To make it easier to identify and select the channels you
want to listen to, your scanner divides the channels into 10
banks (1 to 10) of 20 channels each, a total of 200
channels. You can use each channel-storage bank to group
frequencies.
1PG"6QWEJ"$CPMU
The scanner is preprogrammed with the frequencies
allocated by marine, fire/police, aircraft, ham radio, and
weather services. This is handy for quickly finding active
frequencies instead of searching through an entire band
(see “Searching the One Touch Banks” on Page 16).
±
Marine ±
%JCPPGN (TGSWGPE["*/*\+
01 156.0500
05 156.2500
06 156.3000
07 156.3500
08 156.4000
09 156.4500
10 156.5000
11 156.5500
12 156.6000
13 156.6500
14 156.7000
15 156.7500
16 156.8000
17 156.8500
±
"016'"
±
"
Channel Storage Banks
The scanner is preset so each
bank is turned on (see “Turning
Channel-Storage Banks Off and
On” on Page 18).
One Touch Banks
The frequencies in the scanner's
one touch banks are preset. You
cannot change them.
Marine
Both frequencies (transmission and
reception) are shown for marine
channels used for duplex
transmission.
20-424.fm Page 12 Monday, September 9, 2002 9:44 AM