Radio Shack ET-916 - Manual (Page 11)

11
SETTING THE DIALING
MODE
Set DIAL MODE on the back of the base
for the type of service you have. If you
are not sure which type you have, do
this test.
1. Set DIAL MODE to T .
2. Lift the handset and listen for a
dial tone.
3. Press any number other than 0 .
Note: If your phone system
requires that you dial an access
code (
9 , for example) before you
dial an outside number, do not
press the access code either.
If the dial tone stops, you have
touch-tone service. Leave
DIAL
MODE set to T .
If the dial tone continues, you
have pulse service. Set
DIAL
MODE to P .
SETTING THE RINGER
TONE/VOLUME
You can select one of four different
ringer tone/volume settings while the
phone is not in use.
1. Press VOLUME . The ET-916
sounds the current ringer tone.
2. Repeatedly press VOLUME until
you hear the desired ringer set-
ting.
Each time you press VOLUME , the
ringer changes in this order:
High-volume, high-pitch
Low-volume, high-pitch
High-volume, low-pitch
Low-volume, low-pitch
43-1086.fm Page 11 Tuesday, August 17, 1999 2:39 PM