RIDGID R5010 - Manual (Page 9)

8 9
WARNING:
The tool should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the tool is
not in use. Disconnecting the tool will prevent accidental
starting that could cause serious injury.
ASSEMBLY
INSTALLING AUXILIARY HANDLE
See Figure 2.
An auxiliary handle is packed with the drill for ease of op-
eration and to help prevent loss of control.
To install the auxiliary handle:
n
Open the clamping ring by turning the handle counter-
clockwise.
n Slide the ring of the auxiliary handle onto the spindle collar
of the machine.
n Tighten the auxiliary handle at the desired angle by turning
the handle clockwise.
Note: For convenience the screw has been trapped inside
the auxiliary handle.
To prevent thread damage and possible loss of control, the
auxiliary handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
INSTALLING THE DEPTH GAUGE ROD
See Figure 3.
Follow these steps to install the depth gauge rod.
n
Lock the switch trigger by placing the rotation selector
in the center position.
n Loosen the auxiliary handle assembly by turning the knob
counterclockwise.
n Insert the depth gauge rod as shown in figure 3.
n Tighten the auxiliary handle assembly by turning the knob
clockwise.
Fig. 2
Fig. 3
UNPACKING
INSTRUCTIONS
The drill has been shipped completely assembled.
n
Carefully remove the tool from the box.
n Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Hammer Drill with Auxiliary Handle Assembly
Depth Gauge Rod
Carrying Case
Operator’s Manual
WARNING:
If any parts are missing do not operate this tool
until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
DRILL BIT
TO DECREASE
DRILLING DEPTH
AUXILIARY
HANDLE
ASSEMBLY
TO INCREASE
DRILLING DEPTH
DEPTH GAUGE
ROD
DRILLING
DEPTH
AUXILIARY HANDLE
ASSEMBLY