Rhino Mounts NITRO FN20 - Manual (Page 119)

OPERATION
FN20/FN14 NITRO 02/10 Operation Section 4-29
© 2010 Alamo Group Inc.
OPERA
T
ION
10.1 Starting the Tractor
The procedure to start the tractor is model specific.
Refer to the tractor operator’s manual for starting
procedures for your particular tractor. Consult an
authorized dealer if the starting procedure is
unclear. Ensure the 3-point control lever is in the
lowered position and the PTO is disengaged before
starting the tractor. OPS-U-0033
10.2 Brake and Differential Lock Setting
Make sure the tractor brakes are in good operating
condition. Tractor brakes can be set to operate
independently allowing single rear wheel braking
action or locked together to provide simultaneous
rear wheel braking. FOR MOST DRIVING AND
OPERATING CONDITIONS, THE BRAKE PEDALS
SHOULD BE LOCKED TOGETHER TO PROVIDE
THE MOST EFFECTIVE BRAKING ACTION.
Always disengage the tractor differential lock when
turning. When engaged the differential lock will
prevent or limit the tractor from turning. During
normal cutting conditions, locking the differential
provides no benefit and should not be used. OPS-
U- 0013
Be aware of the operating
conditions. Do not operate the Tractor with weak or faulty brakes. When operating down a
hill or on wet or rain slick roads, the braking distance increases; use extreme care and
reduce your speed in these conditions. When operating in traffic, always use the Tractor’s
flashing warning lights and reduce your speed. Be aware of traffic around you and watch
out for the other guy.
10.3 Operating the Mower Wings
Wings are positioned with hydraulic cylinders. It is recommended that the tractor be equipped with three
hydraulic ports or a 3-spool control valve be used so that each section can be controlled independently.
Ensure the hydraulic cylinders and lines are filled with oil by holding the valve control levers in the raised
position until the cylinders fully retract (wings) and extend (center). Only operate the mower with both wings
fully lowered, NEVER operate the mower with a raised wing. Wait until the blades are at a complete stop
before raising wings. OPS-R-0015