Regency U37-LP PROPANE - Manual (Page 27)

U37 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater 27
4) Remove the two outside frame pieces by
removing two screws per side. See dia-
gram below.
5) At this point you should disconnect the gas
at the valve. You can access it through the
front now that the control panel is off, or you
can access it through the rear pedestal
cover plate.
6) Carefully remove the logs and embers.
7) Remove burner. See diagram below.
Note: Use a magnetic type screwdriver
if possible.
8) Remove all 18 screws holding the burner
tray assembly in place.
9) Carefully lift the burner tray assembly out.
Be careful not to tear gaskets when lifting
out the valve tray; these gaskets seal the
valve from the exterior of the firebox.
10) To replace the burner tray assembly, sim-
ply reverse these instructions.
MAINTENANCE