Radio Shack ET-1111 - Manual (Page 14)

14
Follow these steps to store a number in
memory.
1. Lift the handset.
2. Hold down MEM until Memory
Store and a list of memory loca-
tion numbers appears.
3. Choose a memory location (1–0) by
pressing a number or by repeatedly
pressing
or .
4. To store a name, press SELECT .
Store Name appears.
If you do not want to enter a name,
skip to Step 6.
n> will be
stored as the name ( n is the location
number you selected).
5. To enter a name, use or to se-
lect the characters and or to
move the cursor.
Repeatedly press to view the
characters in alphabetical order.
(The display shows uppercase let-
ters first, then lowercase letters,
numbers, and special characters.)
Notes:
• Press to view the characters in
reverse alphabetical order.
• You can hold down or to scroll
rapidly through the characters.
• If you make a mistake, move the
cursor over the error, then enter the
correct character, or press
DELETE
to delete a character. To delete all
the characters, hold down
DELETE
for at least 1 second.
6. Press SELECT . Store Number ap-
pears.
7. Enter the phone number and any
tone or pause entries (see “Using
Tone Services on a Pulse Line” on
Page 13 and “Entering a Pause” on
Page 15).
8. Press SELECT . The phone beeps
and Memory n Stored appears.
After 2 seconds, Memory Store
appears, and you can repeat Steps
3–8 to store more numbers.
9. When you finish, press MEM to exit
the Memory Store display.
TA LK
43-1111.fm Page 14 Tuesday, June 29, 1999 3:38 PM