Radio Shack ET-1111 - Manual (Page 10)

10
2. Lift the handset, press TALK , and
listen for a dial tone.
3. Press any number other than 0.
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not dial the access code
either.
If the dial tone stops, you have
touch-tone service. Leave
PULSE/
TONE set to TONE .
If the dial tone continues, you have
pulse service. Set
PULSE/TONE to
PULSE .
SETTING THE RINGER’S
VOLUME
Lift the handset from the base or leave
the handset faceup on the base. Press
or (except during a call) to set the
ringer volume. The phone rings at the
selected volume and the display shows
Ringer High or Ringer Low .
TA LK
SETTING AUTO TALK
Your phone is preset so you must press
TALK to answer a call. With auto talk
turned on, you can answer a call by just
lifting the handset from the base, or, if
the handset is away from the base, by
pressing any key.
Follow these steps to turn auto talk on or
off.
1. Lift the handset and press FUNC-
TION . A menu appears with Auto
Talk selected.
2. Press SELECT to change the auto
talk setting. On or Off appears indi-
cating the selected setting.
3. To clear the display when you finish,
press FUNCTION or return the hand-
set to the base.
TURNING CALLER ID/
CALL WAITING ON/OFF
If you have Call Waiting with Caller ID
service, you can set the ET-1111 to
show Caller ID information for an incom-
ing call even while you are already on
the phone.
43-1111.fm Page 10 Tuesday, June 29, 1999 3:38 PM