Radio Shack ET-543 - Manual (Page 13)

13
Notes:
• If you receive a call while you are
storing a number in memory,
press
TALK to answer the call.
After the call, begin again at Step
1 to store the number.
• To change a phone number stored
in memory, simply store a new
phone number in that location.
• To clear a memory location so no
number is stored there, press
MEMORY twice, then press the
location number. A long beep
sounds. The phone number is
now cleared from the memory.
If a buzz sounds, you did not suc-
cessfully clear the memory loca-
tion. Try the process again.
Entering a Pause
in a Memory Number
In some telephone systems, you must
dial an access code (9, for example)
and wait for a second dial tone before
you can dial an outside number. If your
phone is connected to one of these
systems, you might want to enter a
pause at the appropriate point when
you store a phone number in memory.
At the appropriate place in the number,
press
PAUSE to enter a 2-second
pause. P appears. For a longer pause,
press PAUSE again.
Note: Each PAUSE entry uses one dig-
it of memory.
Dialing a Stored Number
There are three ways to dial a stored
number.
Method 1
1. Lift the handset from the cradle
and press TALK so the keypad
and TALK key light.
2. When you hear a dial tone, press
MEMORY , then press the number
buttons for the correct memory
location. The stored number
appears on the display, and the
phone dials the stored number.
Method 2
1. Lift the handset from the cradle
and press TALK so the keypad
and TALK key light.
43-1043.fm Page 13 Tuesday, August 17, 1999 10:36 AM