RCA RTD260 - Manual (Page 26)

Operation in the Operation Modes
Channel Playback Mode
You can playback the selected channels under this mode.
To select channel, press the numeric buttons and then OK or wait for
few seconds timeout to confirm.
To select the previous or next category, press CATEGORY +/-.
To toggle between Channel Playback Mode, Channel List Mode and
Category Tuning Mode, press DISPLAY on the remote.
To toggle among different surround modes(Stereo/PLII Movie/PLII
Music/PLII Emul), press SURROUND.
Note: “Invalid Channel” will be shown on the front panel display if the selected channel is invalid.
“Subscription Updated” will be shown on the front panel display if currently tuned channel changes from subscribed
to unsubscribed or vice versa.
“GCI Updating” will be shown on the front panel display when channel map is updating.
Channel List Mode
You can select from all available channels under this mode.
To select the previous or the next channels, press
/ . To confirm
selection, press OK.
To select desired channels, press the numeric buttons and then OK or
wait for a few seconds for timeout to confirm.
Category Tuning Mode
This mode allows the selection of channels which fall under the current selected category.
To select desired channels, press the numeric buttons and then OK or wait for few seconds timeout to
confirm.
To select the previous or the next channels, press / . To confirm selection, press OK.
To toggle among Channel Name Display, Song Title Display and Artist Name Display, press DISPLAY.
To select the previous or the next category, press CATEGORY+/-.
Save Preset Mode and Recall Preset Mode
You can use presets under Recall Preset mode. Before using presets, you should set presets manually.
Setting Presets Manually
1. In Channel Playback Mode, Channel List Mode and Category Tuning Mode, press MEMORY to enter
Save Preset Mode.
2. The default preset number is “00”. To select the desired preset number, press 0-9 to change it while
it is flashing or press RETURN and wait for a few seconds for the unit to timeout and return to the
previous mode.
3. Press OK to confirm selection. “Saved” is shown on display.
Recall Presets
In Channel Playback mode, press PRESET+/- on the remote to enter Recall Preset Mode. To recall preset
channel, press PRESET/CHANNEL and then / on the front panel or PRESET +/- on the remote or
the numeric buttons to select preset channel and then press OK.
Signal Strength
You can view the signal strength from the display:
Excellent Good Weak or no signal
Note: Adjust the position of the antenna for better reception. Follow the instruction on the User’s Manual of the Tuner.
Illustrations contained in this document are for representation only.
Sirius Satellite Radio
>
> > >
24
EN
RTD260 EN (07_06_06) 15/6/06 4:34 PM Page 28