Renesas H8S/2168 - Manual (Page 25)

20
Section 6 Notice
1. Make sure that pin 1 on the user system IC socket is correctly aligned with pin 1 on the cable
head before inserting the cable head into the user system IC socket.
2. The dimensions of the recommended mount pad for the user system IC socket are different from
those of the MCU.
3. To avoid breaking wires in the cable body, do not place heavy or sharp metal objects on the user
system interface cable.
4. While the emulator station is connected to the user system with the user system interface cable,
force must not be applied to the cable head. Position the emulator station, user system interface
cable, and user system as shown in figure 14.
User system
Cable
Emulator station
Place components so that the cable body
and cable head are parallel to the user system.
Cable head is parallel
to emulator station
Cable head is parallel
to user system
Figure 14 User System Interface Cable Location Example
5. The P1 short connector is for testing. Do not remove the jumper pin inserted in the side of pin 1
and pin 2.
P1
3 1
Figure 15 P1 Short Connector