Connection procedure, External dimensions and a sample foot pattern, Connection procedure (see figure 3) – Renesas M3T-FLX-64NSA User Manual
Page 3
(3/4)
5. Connection Procedure (See Figure 3)
The procedure for connecting the M3T-FLX-64NSA is shown
below.
(1) Mount the NQPACK064SA160 on the target board.
(2) Attach the YQPACK064SA on the NQPACK064SA160.
(3) Secure the four corners of the YQPACK064SA with the
YQ-GUIDE's.
● Do not use the screws included with the
YQPACK064SA for fixing the YQPACK064SA.
● The screwdriver included with the
NQPACK064SA160 is used for fixing the
HQPACK064SA or HQPACK064SA160. Do not use
if for fixing the YQ-GUIDE's.
(4) Attach the M3T-FLX-64NSA on the YQPACK064SA.
(5)
Connect the probe of the emulation pod to the
M3T-FLX-64NSA.
Figure 3 Connection procedure of the M3T-FLX-64NSA
6. External Dimensions and a Sample Foot Pattern
Figure 4 External dimensions and a sample foot pattern of the M3T-FLX-64NSA
M3T-FLX-64NSA
YQ-GUIDE (x4)
YQPACK064SA
NQPACK064SA160
64-pin 0.8-mm-pitch
(64P6N-A, 64P6U-A)
foot pattern
(1)
(2)
(3)
(5)
Use a slotted screwdriver.
FLX100
(4)
: No. 1 pin
Be sure to align the pins.
1
2
15
16
17
18
31
32
47
48
33
34
63
64
49
50
RENESAS
MADE IN JAPAN
1
40 1
40
20
21 20
21
M3T-FLX-64NSA REV.A
J2
J1
31.0
1
2
.0
1
6
.5
31
.0
28.5
Unit: mm
0.5
0.8
13
.2
17
.2
13.2
17.2