Radio Shack 43-683 - Manual (Page 14)

P
u
tting a
Call On H
o
ld
14
2766+0)"#"%#.."10"*1.&
To put a call on hold, press HOLD ( CALL ID/HOLD on the
handset). The indicator for that line lights red on the base,
and the handset display shows
>ebZý >ebZý >ebZý >ebZý
above the line number.
While a call is on hold, you can temporarily place the
handset on the base or use the other phone line without
disconnecting the current call.
±
To release a line from hold and continue your conversation,
press that line’s button on the handset or base. You can
also release a call from hold by lifting the handset if the
handset is on the base, or picking up an extension phone.
You can alternate between the two lines by pressing HOLD ,
then the button for the desired line.
59+6%*+0)"$'69''0"6*'"
*#0&5'6"#0&"
52'#-'42*10'
To switch to the speakerphone while you are using the
handset, press
CALL ID/HOLD on the handset, then press
the in-use line's button ( LINE 1 or LINE 2 ) on the base.
To switch to the handset while you are using the
speakerphone, just lift the handset off the base. Or, if the
handset is off the base, press
HOLD on the base, then press
the in-use line's button ( LINE 1 or LINE 2 ) on the handset.
75+0)"$16*"6*'"*#0&5'6"
#0&"52'#-'42*10'
To use the handset to join a call at the base, or to use the
base to join a conversation at the handset, press the line
button for the line that is in use. You hear a busy tone.
Before the tone ends, press the line button again.
During the call, one party can hang up and the call can
continue. To end the call, you must hang up both the base
and handset.
±
To talk with two parties using both lines, see “4-Way
Conferencing” on Page 16.
± "016'" ± "
Putting a Call On Hold
Pressing HOLD (or CALL ID/
HOLD) again while a call is on hold
does not release the hold. Press
the line button that is on hold.
Using Both the Handset and
Speakerphone
If you hear a high-pitched noise
from the base’s speaker, the
handset and the base are too close
together.