Radio Shack 43-683 - Manual (Page 10)

Adjus
ting t
he
Ringer
10
#&,756+0)"6*'"4+0)'4
The phone lets you control its base and handset ringer
volume separately. You can choose from a high or low
ringer setting for the base and the handset.
1
0
"
6*'
"*
#0&5'6
"
At any time except during a call, press SELECT/VOLUME to
set the handset's ringer volume. The display shows
H_d][hý H_d][hý H_d][hý H_d][hý
>_]^ >_]^ >_]^ >_]^
or
H_d][hýBem H_d][hýBem H_d][hýBem H_d][hýBem
.
1
0
"
6*'
"$
#5'
Set RING VOL on the back of the base to HI , LO , or OFF for
each line (L1 and L2). With RING VOL set to OFF , the base's
ringer does not sound when a call is received, but the
handset (and any other phone connected to the same line)
still rings.
5'66+0)"#761"6#.-
Your phone is preset so you must press LINE 1 or LINE 2 to
answer a call. With Auto Talk turned on, you can answer a
call by lifting the handset from the base or pressing any
number key on the base (or any key on the handset if the
handset is away from the base).
1. To turn Auto Talk on or off, lift the handset and hold
down CALL ID/HOLD until the menu appears with the
pointer at Line 1.
±
2. Use 8 / INTCM or CONF / 9 to select Line 1 or Line 2.
Then press # / 7 . A menu appears with
7kjeýJWba 7kjeýJWba 7kjeýJWba 7kjeýJWba
selected.
3. Press SELECT/VOLUME to change the setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears indicating the selected setting.
4. Return the handset to the base.
5'66+0)"%#..'4"+&1%#.."
9#+6+0)
If you have Call Waiting and Caller ID service, you can set
the phone to show Caller ID information for an incoming call
even while you are already on the phone.
ý Caller ID/Call
Waiting is set separately for each line.
1. Lift the handset and hold down CALL ID/HOLD until the
menu appears with
B_d[ý' B_d[ý' B_d[ý' B_d[ý'
selected.
± "016'" ± "
Auto Talk is set for each line
separately. For example, when you
turn Auto Talk on for Line 1 only,
you must press LINE 2 to answer a
call on line 2.