Preparation, Powering the cb, Using the power jack and ni/al switch – Ricoh TRC-239 User Manual

Page 6: You must set, Cor- rectly. follow these steps to set, As follows: • set it to

PREPARATION

POWERING THE CB

You can power your TRC-239 from any of these
sources:

• internal batteries (not supplied)

• vehicle battery power (using an optional

adapter)

• household AC power (using an optional adapter)

Using the POWER Jack and NI/AL
Switch

The

POWER

jack lets you connect an external power

source (such as your vehicle’s battery) or an external
AC adapter (not supplied), or an external charger
(not supplied) to charge rechargeable batteries (not
supplied) while they are in the TRC-239. Before con-
necting anything to

POWER

, you must set

NI/AL

cor-

rectly.

Follow these steps to set

NI/AL

1. Slide the battery compartment cover in the direc-

tion of the arrow to remove it.

2. Remove any installed batteries.

3. Set

NI/AL

as follows:

• Set it to

to use alkaline batteries.

SERIAL

NUMBER

FOR RADIOSHACK. A DIVISION OF TANDY

CUSTOM MANUFACTURED IN THAILAND

CORPORATION. FORT WORTH. TEXAS 76102

FCC ID: AAO2101678

(1) This device may not cause harmful interference, and

including interference that may cause undesired operation.

(2) this device must accept any interference received,

Operation is subject to the following two conditions:

This device complies with Part 15 of FCC Rules.

21-1628.fm Page 6 Tuesday, January 25, 2000 9:30 AM