Ricoh TRC-239 - Manual (Page 12)

12
you finish, disconnect the power supply from AC
power before you disconnect the power cord
from the TRC-239.
If batteries are installed for portable use, make sure
NI/AL inside the battery compartment is set to the
correct position (see “Using Batteries” on Page 7).
Follow these steps to connect the TRC-239 to AC
power.
1. Connect the Adaptaplug adapter to the power
supply’s cord, setting TIP to + (positive).
2. Plug the barrel plug into the TRC-239's POWER
jack.
3. Connect the other end of the power cord to your
vehicle’s cigarette-lighter socket.
4. Plug the power supply into a standard AC outlet,
then turn on the power supply before you turn on
the TRC-239.
CONNECTING THE ANTENNA
Caution: To prevent damage to your TRC-239, you
must connect an antenna before you operate it.
Follow these steps to attach the supplied flexible an-
tenna to your TRC-239.
21-1628.fm Page 12 Tuesday, January 25, 2000 9:30 AM