NEC GT1150 - Manual (Page 39)

E – 31
REMOTE 1 Connector
Pin Configuration of Optional CTL-6010 Cable
REMOTE 1 connector
of the Switcher mini D-
sub 15 pin (female) REMOTE 1 connector of
the Projector mini D-sub
15 pin (female)
Shield (frame ground)
Pins without a number are open.
5 1 4 2 3
10
11 12 13 14 15
6 9 7 8
This connector is used for either connecting the ISS-6020/ISS-6020G Switcher or a third
party external control device. When the Switcher is used, connect it with the optional control
cable (15-15 pin; 50 ft./16m; CTL-6010) to this connector.
When using with the Switcher ISS-6020/ISS-6020G, connect No. 1,2,6,7,9 and15 pins of
the projector to the same No. pins of the switcher as shown below.
When used with the Switcher.
Pin No. FUNCTION
1, 2, 6 and 7 Sending and receiving data when the Switcher is used.
9 Identifying the Projector
15 Ground
8,11 and 12 Used inside the Projector. Normally set to OPEN.
1 1
2 2
15 15
6 6
9 9
7 7