NorthStar Navigation Northstar NS100 - Manual (Page 2)

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of FCC Rules. These limits are designed to provide a reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try and correct the interference by one or more of the following measures:
• reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• consult the dealer or an experienced radio/TV technician for help.
IMPORTANT
1. DSC functions will not operate until your MMSID has been entered. Refer to page 32 for details.
2. The radio channels installed into the NS100 radio may vary from country to country, depending upon the
model, and government or national communications authority regulations.
3. Northstar recommends that you check the radio operating licensing requirements of your country before using
the NS100 radio. The operator is solely responsible for observing proper radio installation and usage practices.
4. A DSC warning label is supplied with the NS100 radio. To comply with FCC regulations, this warning label must
be
affi xed in a location that is clearly visible from the operating controls of this radio. Make sure that the
chosen location is clean and dry before applying this warning label.
RF Emissions Notice:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device’s antenna
must be installed in accordance with provided instructions; and it must be operated with minimum 96 cm spacing between the
antennas and all person’s body (excluding extremities of hands, wrist and feet) during operation. Further, this transmitter must
not be co-located or operated in conjunction with any other antenna or transmitter.