NuTone LA522WH User Manual
Page 3
3
TRouBleshooTing
The range of the door chime de-
pends on location, temperature and
battery condition. If you are having
problems with this product, please try
the solutions listed below.
chime rings on its own:
• Button frequency jumpers and
chime frequency jumpers
MUST BE SET TO THE SAME
FREqUENCY CODE. Change
the button frequency jumpers and
chime frequency jumpers to a dif-
ferent code.
Regulatory Information
The user is cautioned that changes
or modifications not expressly ap-
proved by the party responsible for
regulatory compliance could void
the user’s authority to operate this
equipment.
PUSH
BUTTON
BATTERY
{
Button Frequency Jumpers
(inside pushbutton case)
Batteries are ok, but chime does
not work when installed:
• Mounting the chime or button
directly on metal, concrete or near
metal studs reduces the range.
Use /4” to /2” wood shims to
move the chime or doorbell button
off of the surface.
• Do not mount the chime too close
to ground level concrete slabs
which may also reduce the range.
Mount the chime away from the
floor.
• Try different locations for the
chime closer to the button. Also,
try to orient the chime at a differ-
ent angle to increase the range.
Range is most effective to the
sides of the button.
Button Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)
FReQuencY code
- SAMPLE SETTING -
This device complies with Part 5
of the FCC rules. Operation is sub-
ject to the following two conditions:
. This device may not cause
harmful interference, and
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
chime Fre-
quency
set Jumpers
1
6
-
+
-
+
-
+
chime doesn’t sound:
• Make sure the button and the
chime are set to the same frequen-
cy code.
• Replace the button battery. Also
check chime batteries.
chime Frequency Jumpers
(Jumpers removed (OFF) from 2, 4, 6)