Network Equipment Technologies 500 - Manual (Page 26)

10003137.00 Rev.1
3-6 Status line
6 Call reference
OXXXX call reference originating (Basic Rate OXX)
DXXXX call reference destination (Basic Rate DXX)
7 Layer 3 decode
SHORT display message type only
MED display message type and information elements
LONG display message type, information elements and full decode of
information elements
8 Layer enable
-- alarms displayed; layers 2 and 3 suppressed
L2 layer 2 displayed in full; layer 3 suppressed
E2 only Exception Conditions are shown on layer 2; layer 3 suppressed.
This displays SABME, UA, DISC, REJ, FRMR and RNR frames but
suppresses RR and INFO frames
L3 layer 3 displayed; layer 2 suppressed
L2 L3 layers 2 and 3 displayed in full
E2 L3 (default) layer 2 exception conditions and layer 3 displayed
HEX all messages displayed in hex
9 Capture and filter status
-- traffic not filtered or captured
FILT traffic filtered
CAPT all traffic captured to disk
CA-FI traffic filtered before capture
10 CES (BRI only)
C XXX CES of active data link