Network Equipment Technologies 500 - Manual (Page 20)

10003137.00 Rev.1
2-8 Starting PAP
Starting PAP
To start the program:
1 Either:
• from Program Manager, double-click on the icon; or
• from MS-DOS, change to the PAP directory and type one of the following:
PAPTS14
PAPTS13
PAPETSI
PAPETSIB
PAPDASS2
PAPDPNSS
To change the COM port or baud rate settings, use the Port and/or Rate commands (see
Chapter 4 — Commands). Changes are saved when the program exits and will be used
each time the program starts.