Nokia 12 GSM MODULE REMOTE I/O - Manual (Page 41)

OUTPUT 3: OFF
OUTPUT 4: OFF
OUTPUT 5: OFF
OUTPUT 6: OFF
OUTPUT 7: OFF
OUTPUT 8: OFF
OUTPUT 9: OFF
9.3.6 Inverting Outputs
Use the Output_Invert X commands to invert digital output states. The
state of an output can be changed without knowing its previous state. Note that
all example control messages in this chapter use the “term123” identifier string
and the password property is set off (see Table 11).
Table 11. Output_Invert X commands
Command Type Command Comments
Output_Invert X term123 Output_Invert X
Response:
OUTPUT_INVERT X: OK
OUTPUT X: Y
The X refers to output pin number, X=1,2,3,4,5,6,7,8,9.
The Y refers to either ON or OFF
The command inverts
output pin X to
opposite state.
Output_Invert All term123 Output_Invert
All
Response:
OUTPUT_INVERT ALL: OK
OUTPUT 1: X
OUTPUT 2: X
OUTPUT 3: X
OUTPUT 4: X
OUTPUT 5: X
OUTPUT 6: X
The command inverts
all output pins to
opposite state.
37/49