Electrolux EHI 6740 FOK - Manual (Page 14)

Problem Possible Remedy
comes on. No cookware is on the
cooking zone. Put cookware on the
cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone. Use cookware with cor-
rect dimensions.
The cookware do not cov-
er the cross. Cover the cross fully.
and a number come
on.
There is an error in the ap-
pliance. Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If
comes
on again, speak to the
service centre.
comes on. The electrical connection
is incorrect. The supply
voltage is out of range. Speak to a qualified elec-
trician to check the instal-
lation.
comes on. There is an error in the ap-
pliance because a cook-
ware boils dry. The over-
heating protection for the
cooking zones and the
Automatic Switch Off op-
erate. Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
“Cookware for the induc-
tion cooking zone” to see
if your cookware is com-
patible with the appliance.
comes on. The cooling fan is blocked. Check if objects block the
cooling fan. If comes
on again, speak to the
service center.
comes on. The electrical connection
is incorrect. The appliance
is connected only to one
phase. Connect the appliance as
you see it in the connec-
tion illustration.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
14 www.electrolux.com