NISSAN 2010 GT-R - Manual (Page 22)

PASSENGER REAR SEAT ENTRY
FROM INSIDE THE VEHICLE
Ⅲ Push the passenger’s seat slide switch, located
on the inboard side of the passenger front seat,
forward to the desired position where it will be
easier to get in or out of the rear seat.
Ⅲ Lift up the lever and tilt the seatback forward.
Ⅲ To return the seat to its original position, lift up the seatback
and use the seat adjustment switch to return the seat to its
original position.
FROM OUTSIDE THE VEHICLE
Ⅲ Lift up the lever
and tilt the seatback forward.
Ⅲ Move the seat adjustment switch forward
or backward to a position where it will be
easier to enter the rear seats.
Ⅲ To return the seat to its original position, lift up the seatback and use the seat adjustment
switch to return the seat to its original position.
HOMELINK
ா UNIVERSAL TRANSCEIVER
SYSTEM OPERATING TIPS
Ⅲ Garage doors, electrical gates, entry doors, etc. will be activated during programming.
To avoid injury, make sure that people and objects are clear of all doors or gates during
programming. Your vehicle’s engine should be turned off while programming the
HomeLink
ா Transceiver.
Ⅲ To program your HomeLinkா Transceiver to operate a garage door, gate, or entry door
opener, home or office lighting, you need to be at the same location as the device.
NOTE: Garage door openers (manufactured after 1996) have “rolling code pro-
tection”. To program a garage door opener equipped with “rolling code protec-
tion”, you will need to use a ladder to get up to the garage door opener motor to
be able to access the “smart” or “learn” program button.
20