NordicTrack AudioStrider 30725.0 User Manual

Page 10

12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

11. The Console (11) can be operated with four

1.5V “D” batteries (not included); alkaline batter-

ies are recommended. IMPORTANT: If the

ellipical exerciser has been exposed to cold

temperatures, allow it to warm to room tem-

perature before inserting batteries into the

Console. If you do not do this, the console

displays or other electronic components

may become damaged. Locate the two battery

covers on the back of the Console. Press the

tabs on the battery covers, and remove the bat-

tery covers. Next, insert two batteries into each

battery compartment; make sure that the bat-

teries are oriented as shown by the symbols

inside the battery compartments. Then, reat-

tach the battery covers.

The Console (11) can also be operated with a

regulated 6-volt DC 2-amp power supply (not

included). To purchase a power supply, call

your local Sears store. To avoid damaging

the console, use only a manufacturer-sup-

plied power supply. Plug one end of the power

supply into the jack on the elliptical exerciser;

plug the other end into an outlet installed in

accordance with all local codes and ordinances.

Battery

Cover

Battery

Cover