NETGEAR ME103 User Manual
NETGEAR Handset Cordless Phone
Table of contents
Document Outline
- Trademarks
- Statement of Conditions
- Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
- Canadian Department of Communications Compliance Statement
- CE Declaration of Conformity
- Contents
- Chapter 1 About This Manual
- Chapter 2 Introduction
- Chapter 3 Basic Installation and Configuration
- Observing Placement and Range Guidelines
- Understanding ME103 Wireless Security Options
- Installing the ME103 802.11b ProSafe Wireless Access Point
- How to Log In to the ME103 Using Its Default NetBIOS Name
- How to Log In to the ME103 Using Its Default IP Address
- Understanding Basic Wireless Settings
- Understanding Basic Wireless Security Options
- Using the Basic IP Settings Options
- Chapter 4 Maintenance
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I am using EAP-TLS security but get disconnected.
- I cannot connect to the ME103 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Specifications
- Appendix B Wireless Networking Basics
- Appendix C Network, Routing, Firewall, and Cabling Basics
- Appendix D Preparing Your PCs for Network Access
- Glossary
- Index