NETGEAR ME103 - Manual (Page 24)

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point
3-3 Basic Installation and Configuration
August 2003
Default Factory Settings
When you first receive your ME103, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
“ME103
Wireless Access Point Rear Panel” on page 2-7 .
FEATURE FACTORY DEFAULT SETTINGS
User Name (case sensitive) admin
Password (case sensitive) password
Operating Mode Access Point
Access Point Name NETGEARxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP DHCP client
IP Configuration
(if DHCP server is unavailable)
IP Address: 192.168.0.224
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Primary DNS Server: blank
Secondary DNS Server: blank
Network Name (SSID) NETGEAR
Broadcast Network Name (SSID Enabled
802.11b
Radio Frequency Channel
11
WEP Disabled
Restricting connectivity based
on MAC Access Control List
Disabled
WEP Disabled
802.1x Disabled
SNMP Disabled