Creating a configuration plan, Organize the plan, Creating a configuration plan -6 – NEC MH160 User Manual
Page 40: Organize the plan -6
4-6 Using the Settings Editor
NEC MH150/MH160 Mobile Handset Administration Tool-Installation and User Guide - Issue 1
Creating a Configuration Plan
Although not necessary for using the Handset Administration Tool, a
configuration plan can maximize its efficiency and save countless hours
of handset option management. An example of a configuration plan is
provided in
Table 4-2, “Configuration planning worksheet sample,” on
.
Organize the plan
Determine which options should be categorized as each type—system,
group or user. Generally, system options are listed on the Network tab,
group options are on the PTT tabs and user options are on the profile
tabs. The Phone Config tab contains a mix of user and system types.
Do not create a plan that saves an option in two different categories. Option
categories should be established and should not overlap. Example: Speakerphone
and Push-to-talk settings are typically tagged as Grp options and saved as Group
files.
Profiles:
Silent
Vibrate
Loud
Soft
Custom
N/A
Noise Mode
Ring in Speaker/
Headset
Warning Tones
Key Tones
Push-to-Talk
(Ring option)
Telephone Ring
Message Alert 1
Message Alert 2
(Ring option settings)
Ring Cadence
Ring tone
Ring volume
Vibrate Cadence
Ring Delay
Your handsets may have different options than those available in the Handset
Administration Tool. When a handset is placed in the cradle, it is checked for certain
features, such as the Regulatory Domain version. The HAT will turn controls on/off
based on the information that it gathers. If your handsets have options that are not
yet programmed into the HAT, those options will require manual setting if the factory
default is not desired.
For user convenience and efficiency, when the Write Handset button is clicked,
every option set under the Handset settings column in all nine tabs is written at the
same time. Each tab's options are NOT written separately. Be sure that you set all
options before copying the configuration to the handset.
Tab
Contents-Admin Menu
Contents-Config Menu
NOTE
NOTE
NOTE