Navigon 33xx - Manual (Page 18)

User’s manual NAVIGON 33xx | 43xx max
- 18 - Operating the NAVIGON 33xx | 43xx max
GPS
The GPS symbol can indicate the following GPS reception states:
No GPS
(No symbol): The built-in GPS receiver is not operational.
Contact customer service if the problem persists.
No Signal : Data is being received from less than three satellites.
Position cannot be calculated.
GPS Ready
: Data is being received from at least three satellites.
Position can be calculated.
For details of the GPS status refer to chapter "GPS Status, saving the
current location" on page 55.
Compass
The Compass symbol indicates in which direction you are currently
heading. It can indicate the following points of the compass: N, NE, E,
SE, S, SW, W, NW.
TMC (Traffic Information)
The NAVIGON 33xx | 43xx max has an integrated TMC receiver which
provides the navigation system with traffic information updates. If
necessary it can change your route dynamically, for example in order to
avoid a traffic jam.
Note:
This function is only available if TMC traffic messages are being
transmitted in the country in which you are travelling. This is not the
case in all countries.
The TMC symbol can display the following TMC reception status:
Tuning
(in red): The TMC receiver is operational but cannot find a
transmitter that is sending TCM signals. There are no active traffic
messages.
Tuning: The TMC receiver is operational but cannot find a station that
is transmitting TMC signals. Traffic messages are active however. This
can be the case, for example, when travelling through a tunnel.
TMC on Standby
(in grey): Traffic messages can be receiverd.
Note:
The TMC antenna is integrated in the car charger cable. The
Tuning
symbol may still appear therefore when the car charger cable is
not connected to the NAVIGON 33xx | 43xx max.