Nuvo T2 - Manual (Page 26)

4.1 Custom Regional Setup
Page 25
4.1 Custom Regional Setup: Some countries operate at a tuning
standard outside the four preset regions. The Custom setting
allows specific parameters. One determining factor for tuning
is the “Pre-emphasis”. The two choices for this are 50µS
(microseconds) and 75µS. The custom setting also allows for
specific setting of the minimum and maximum tuning
capability and the individual tuning steps for FM and AM.
4.2 Tuning Parameters: This section determines how the T2
tunes up and down. Seek/Scan Levels for each band, FM, AM,
and Weatherband sets the signal strength parameter for
searching stations. The lowest level 0 causes the tuner to stop
at any frequency with a very low signal. Level 4 (High), stops
only when a very strong signal is detected. The factory default
is Level 2 (Medium), which searches for a moderate signal.
This setting changes the necessary signal threshold, which is
the minimum signal level required for the T2 to recognize it
and lock on to the frequency.
4.2 Tuning Parameters
4.3 Fine Tuning: When selected, Fine Tuning changes the
tuning standard for FM from the default .10 MHz tuning to .05
MHz step tuning, and AM will tune by single kHz increments,
rather than the default 10 kHz for USA and Canada, and 9 kHz
for Europe. Smaller tuning steps allow access to all station
frequencies.
4.3 Fine Tuning
Advanced Settings
The T2 software contains several specialized settings for more
advanced setup. Clicking on view and selecting “Advanced”
will expand the tabs as discussed in the next section to allow
access to this functionality.
4.0 Advanced Config
The T2 software allows for more advanced settings that if
necessary allow you to tweak the tuner's operation.
4.0 Advanced Config