Eizo 531L - Manual (Page 70)

English
70
6. USING THE TERMINAL PROPERTIES
6-4. Network Settings
Click [Network] tab to set network information for the eClient.
NOTE
• All settings shown here are previously adjusted on the “WBT Setup Wizard”.
• Please set the properties depending on the eClient connection settings.
[Use PPP connection or another network adapter]
...................................Click to use a modem connection to the WTS.
(531L/531LT-GR only)
To connect to the WTS with a LAN network, set the following.
[Obtain an IP address from a DHCP server]
...................................This allows the user to receive IP information from a
DHCP service automatically. The DHCP service of a
server must be in operation to receive the information.
[Specify an IP address.] .......If not using a DHCP service, please select this and
enter the information shown below.
[IP address] .........................Type the eClient IP address.
[Subnet Mask].....................Type the subnet mask.
[Gateway] ...........................Type the Gateway IP address.
[Terminal Name] ................Type a name to recognize this unit from others on the
network (only in use of the RDP protocol).