beautypg.com

0 technical configuration, 1 overview, 1 power switch (on/off) – Navman LA000507 User Manual

Page 6: 2 configuration dip switch, 3 function leds, 4 reset switch, 5 clock out connector, 6 serial port 1

background image

6

LA000510C © 2006 Navman NZ Ltd. All rights reserved. Proprietary information and specifications subject to change without notice.

3.0 Technical configuration

This section provides a detailed description of all the technical aspects and configurable

functionality of the Jupiter 20 GPS Development Unit.

3.1 Overview

Figure 3-1 illustrates the connectors, switches and LEDs available on the Development Unit.

1 2 3 4 5 6 7 8

CTS 206-8 T114

'03

#/.&)'52!4)/.

0/7%2

2%3%4

4)-%

-!2+

0/7%2

$'03

!#4)6%

.-%!

!3352%$

power switch

configuration switch

function LEDs

reset switch

Serial Port 1

Antenna

DR

Clock

Out

Serial Port 2

-

+

DC Power

9-16Volts

1PPS output

comm 1

NMEA & binary

comm 2

(RTCM)

dead reckoning

input signals

DC input J1

‘U’ slot for antenna

cable (custom)

SMA antenna

connector

Figure 3-1 Front and back panels of the Jupiter 20 development unit

3.1.1 Power switch (ON/OFF)

The switch on the front panel controls primary power to the Jupiter 20 receiver module inside.

The power status LED (see section 3.3) indicates status: if lit, the module has primary power

supplied. If the configuration DIP switch 5 is on and Jumper JB5/6 linked, the module’s

secondary supply SRAM and RTC will continue to be powered when the power switch is off.

Only removal of the DC power input at the rear of the unit will stop secondary power being

applied (assuming Jumper JB5/6 and switch 5 are correctly set). Having this secondary power

supply applied means that the Jupiter 20 will have a ‘hot start’ capability when primary power is

re-applied within 4 hours, and a ‘warm start’ thereafter, by maintaining last position, current time

and satellite ephemerides.

3.1.2 Configuration DIP switch

The configuration DIP switch on the front panel provides the ability to configure the Jupiter

20 module, offering flexibility depending on the specific application. Refer to section 3.2 for

a description of the functionality of each individual switch, including the typical settings when

using the Jupiter 20 module.

3.1.3 Function LEDs

The four LEDs on the front panel indicate the current status of basic features associated with

the Development Unit. Refer to section 3.3 for a description of the function of each LED.

3.1.4 Reset switch

A reset push button is provided on the front panel to generate a receiver system hardware reset.

3.1.5 Clock out connector

The Clock out connector, located on the rear panel of the Development Unit, can be used to

provide module generated timing signals. Refer to section 3.4 for more detailed information.

3.1.6 Serial port 1

This host serial port is used to send and receive serial data. This port is used as the default, with

transmission in NMEA format at the rate of 9600 Baud. Use 9-pin D-subminiature connectors

with these serial ports.