Nortel Networks 4060 - Manual (Page 12)

Set up the DECT Handset 4060
12
Insert the batteries
Figure 1 illustrates how to insert batteries in the DECT Handset 4060.
Figure 1: Insert the batteries
Steps
1. Lift the back cover of the handset as shown in the diagram.
2. Insert the batteries in the battery compartment, ensuring that the
polarity is correct. The + - poles of the batteries must correspond to
the + - markings in the battery compartment.
3. Replace the cover by placing it on the compartment at a slight angle
and pressing it down until it clicks into place.
CAUTION
Do not charge the batteries unless you use the supplied
charger and the proper batteries.
CAUTION
Do not let the battery or the charger come into contact
with conductive metal objects.
3
1
2