NuTone NP60000 - Manual (Page 6)

- 6 -
1. SELECT BLOWER OPTION AND INSTALL DUCTWORK
Either an interior or exterior blower or in-line blower may be used with this hood. The NuTone Premier 60000 Series must
be installed with blower models RM325H, RM326H, HLB3, HLB6, HLB9, HLB11, 331H, 332H, 335 or 336 only.
Other blowers cannot be substituted. (Blowers sold separately).
NOTE: In addition to the blower models listed above, this hood is also compatible with older internal versions 325H
and 326H. However, discard the installation instructions included with those blowers and contact our technical
support to obtain replacement instruction.
Plan where and how the ductwork will be installed.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 up to 6, 9, 10, 11,
13 and up of this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use 2” duct tape to
seal duct joints.
7" (178 mm)
ROUND DUCT
ROOF CAP
7" (178 mm)
ROUND
ELBOW
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
WALL CAP
HOOD
DECORATIVE
FLUE
or SOFFIT
12"
(305 mm)
HH0024A
MODEL RM325H SINGLE BLOWER
TYPICAL DUCTWORK
10" (254 mm)
ROUND DUCT
ROOF CAP
WALL CAP
HOOD
DECORATIVE
FLUE
or SOFFIT
4-1/2" x 18-1/2"
to 10"
(114 x 470 to
254 mm) ROUND
TRANSITION
(see page 4)
HH0025A
12"
(305 mm)
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
MODEL RM326H DUAL BLOWER
TYPICAL DUCTWORK
EXTERIOR BLOWER
EXTERIOR
BLOWER
HOOD
DECORATIVE
FLUE
or SOFFIT
HH0026A
12"
(305 mm)
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
332KR
ROUGH-IN KIT
(see page 5)
10" (254 mm)
ROUND DUCT
10" (254 mm)
ROUND ELBOW
MODEL 331H, 332H, 335 OR 336
EXTERIOR BLOWER TYPICAL DUCTWORK
In-line blower
10” round duct
HH0066A
24” minimum
above cooking
surface
Roof cap
Wall
cap
Hood
MODEL HLB3, HLB6, HLB9 OR HLB11
IN-LINE BLOWER TYPICAL DUCTWORK