Napoleon Fireplaces BGD40-P - Manual (Page 25)

25
W415-0299 / C / 03.12.03
Ensure that the
door is properly
clipped onto the
steel lip to pre-
vent overheat-
ing, glass break-
age and / or dis-
colouration of
the upper trim.
To install the door(s),
hook it over the steel lip
located above the door
opening.
Secure with screws
along the bottom of
the door. Tighten
screws snugly.
Do not
over-tighten.
DOOR
STEEL LIP
FIGURE 55
FIGURE 56
END DOOR INSTALLATION
FIGURE 57
L36 LOUVRE INSTALLATION
FIGURE 54 a-c
HOOD
Attach the hood by pressing the
top flange into the clips along
the top of the louvre opening.
Secure using a screw through
the centre slot.
LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
right corners of the unit.
A
CLIPS
CENTRE
SLOT
FLANGE
SLOT
TAB
B
C
HINGE
CLIP
SLOT
A
B
C