Nautilus T7.16 - Manual (Page 5)

N
A
U
TI
LU
S
®
O
P
ER
A
TI
O
N
3
Treadmill Magnetic Safety Stop Cord
qqqqq
IMPORTANT
The emergency stop
cord should always be in use while on your treadmill.
The magnetically activated key is located on the
bottom of the display as shown. This magnetic key
is an emergency shut off and will abruptly stop the
walking belt should you fall down while using the
treadmill. Removing this magnetic key while not in
use will prevent children or unwanted users from
operating the treadmill.
Safety Cord Deactivation
While we recommend using the Safety Stop Cord,
more experienced users may fi nd they prefer to use
the treadmill without this cord in place. To deactivate
the Safety Stop Cord and permit unrestricted access
of the treadmill follow the steps below.
1. Press and hold the SPEED UP and SPEED DOWN Keys for three seconds
while in Standby Mode. The Management menu will be entered and Total
Hours will be shown on the upper display.
2. Press the ENTER Key until SAFETY CORD – ON is displayed.
3. Pressing the SPEED UP Key will change display to read SAFETY CORD – OFF.
4. Press the ENTER Key to save the new value and press STOP to exit
Management Menu. The Safety Cord feature is now deactivated
qqqqq
IMPORTANT
If at any time the safety key is put back in place
THE SAFETY CORD FEATURE REACTIVATES AUTOMATICALLY and must be
turned off again using the above steps.
INSTALLATION & OPERATION
Emergency
Stop
Magnet
(T7.16)
(T7.18)
Attach magnetic safety cord onto
clothing as shown.
T7_16-18_OM.indd 3 11/12/04 3:29:43 PM