Nautilus T7.16 - Manual (Page 4)

N
A
U
TI
LU
S
®
IN
S
TA
LL
A
TI
O
N
C HA NG I N G T H E G A M E I N H EA LT H A N D F I T N E S S ™
2
Treadmill Power Plug Receptacles
The Pro Series treadmills have two power plug receptacles allowing you plug
in the treadmill from the front or the rear of the machine. The rear power cord
receptacle, located underneath the right side of the side rail, should be used if
the treadmill is going to be placed in the center of the room facing away from the
wall. The front power cord receptacle, located on the front side of the motor pan,
can be used if the treadmill is placed facing a wall or parallel to a wall.
INSTALLATION & OPERATION
Turning on the Power
After you have determined which end of the treadmill to plug in, the treadmill
can be turned on by moving the power switch located at the front of the
treadmill, to the ON position. The unit will be in Sleep Mode, all displays will be
blank. Pressing any key, except STOP, will cause the displays to light up and the
treadmill to enter Standby Mode. Unit will return to Sleep Mode after 30 minutes
of inactivity. Be sure to turn treadmill off when not in use. (Pressing STOP while
in Standby mode brings unit to Sleep mode, but does not turn off power.)
Understanding the Display and Controls
The treadmill display is a computerized panel used to operate the treadmill and
see all workout data and operational status. You should familiarize yourself with
the operation of the treadmill and the location of all keys before beginning use.
Power Switch
Attach power cord here if your
treadmill will be facing a wall
or will be parallel to a wall.
Attach power cord
here if your treadmill
will face away from
the wall .
T7_16-18_OM.indd 2 11/12/04 3:29:27 PM