NETGEAR N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Page 86
86
|
Chapter 7. Advanced Settings
N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
c.
Clear the corresponding Disable Wireless Client Association check box (make
sure it is not selected).
d.
Enter the MAC addresses for AP 2 and AP 3 in the Repeater MAC Address 1 and
Repeater MAC Address 2 field.
e.
Click Apply.
2.
Set up AP 2 and AP 3 to be wireless repeaters.
a.
In the Wireless Repeating Function screen for AP 2 and AP 3, select the Enable
Wireless Repeating Function
check box.
b.
Select the Wireless Repeater radio button.
c.
Clear the corresponding Disable Wireless Client Association check box (make
sure it is not selected).
d.
Enter the MAC addresses for your wireless router in the Base Station MAC Address
field.
e.
Click Apply.
3.
Verify the following for all access points:
•
Each access point operates in the same LAN network address range as the LAN
devices.
•
The access points are on the same LAN. That is, the LAN IP addresses for the access
points are in the same network.
•
If you are using DHCP, access point devices are set to Obtain an IP address
automatically (DHCP Client) in the Basic Settings screen.
•
Access point devices use the same SSID, channel, authentication mode, and
encryption.
Verify connectivity across the LANs. A computer on any LAN segment should be able to connect
to the Internet or share files and printers with any other PCs or servers connected to any of the
three WLAN segments.