Lan setup – NETGEAR N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Page 71
Chapter 7. Advanced Settings
|
71
N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as DHCP and Routing
Information Protocol (RIP). The wireless router is shipped preconfigured to use private IP
addresses on the LAN side and to act as a DHCP server. The wireless router’s default LAN
IP configuration is as follows:
•
LAN IP address
. 192.168.1.1
•
Subnet mask
. 255.255.255.0
These addresses are part of the private address range designated by the Internet
Engineering Task Force (IETF
http://www.ietf.org
) for use in private networks, and should be
suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in the LAN Setup screen.
Note:
If you change the LAN IP address of the wireless router while
connected through the browser, you are disconnected. To
reconnect, open a new connection to the new IP address and log in.
To change the LAN settings:
1.
Select Advanced > LAN Setup. The following screen displays:
2.
Enter the LAN Setup configuration, and click Apply to save your changes.