Newcon Optik LRB 4000CI User Manual

Page 26

socket and then push gently the plug holding it by its
casing (3, Fig. 5) until click.
To detach the cable slide sleeve (2, Fig. 5) away from the
unit and pull the plug out.
The communication port must be initiated prior to
connecting the unit to the computer. The data is
transmitted as hex string code with fixed baud rate of
38400 bit/sec, 8 bits, one stop bit, and no parity.

5.12 GPS interconnectivity

LRB 4000CI can transmit the acquired data to a GPS
receiver using DB15 connector and PLGR/DAGR
protocol. An optional cable is required.
To work with GPS, perform the following steps:


Switch the rangefinder to PLGr mode;



Choose dFLt measuring mode;



Connect the rangefinder and GPS unit with the cable.

For each measurement GPS will display the absolute
coordinates of your target.
NOTE: If the rangefinder is not set initially to dFLt
mode, the GPS will not operate properly.
NOTE: GPS unit automatically adjusts coordinates to
reflect actual magnetic declination. Therefore,