Newcon Optik LRB 4000CI - Manual (Page 19)

18
5.5 Operation and service modes
Pressing Mode button (5, Fig.1) in Ready mode switches
the unit between modes of operation, to activate any
desired mode from the menu you must confirm your
selection by pressing Action button (6, Fig.1). The unit
has the following modes of operation:

Ready – Unit is ready to perform measurements
 dFLt – sets default mode of operation with factory
settings,
 GAtE – allows to set gating distance for
measurement
 Std – allows the user to select single action
measurements:
o Distance only (d)
o Compass Only (C)
o Elevation Only (E)
o Speed Only (S)
o Height Only (H)
o Speed + Distance (Sd)
o Distance +Compass + Elevation (dCE)
 Unit – allows the user to select units of desired
measurements,
o Distance from M to Y