Nexgrill 720-0133-LP User Manual

Page 22

USING SIDE BURNER

WARNING: IMPORTANT!

USING THE SIDE BURNER:

Inspect the gas supply hose prior to turning
the gas “ON”. If there is evidence of cuts,
wear or abrasion, it must be replaced prior to
use. Do not use the side burner if the odor of
gas is present.

WARNING: Always keep your face and body
as far away from the burner as possible when
lighting.

LIGHTING INSTRUCTIONS

To light the side burner, remove any cooking
utensils from the burner grate. Push and turn
the control knob counterclockwise to the “HI”
position. If the burner does not light, turn the

functioning, see the following section for
match lighting.

MATCH LIGHTING

Hold a lit extended match or lighter near the
side burner ports, turn the control knob
counterclockwise to “HI”. Move your hand
immediately once the burner is lit. Rotate the
control knob to the desired setting.

Burner flames should be blue and stable with
no yellow tips, excessive noise, or lifting. If any
of these conditions exist call our customer
service line. If the flame is yellow, it indicates
insufficient air. If the flame is noisy and tends
to lift away from the burner, it indicates too
much air.

CARE AND MAINTENANCE

CARE FOR YOUR STAINLESS STEEL
GRILL

The grill is made from non-rusting and non-
magnetic stainless steel. There are many
different stainless steel cleaners available.
Always use the mildest cleaning procedure
first, scrubbing in the direction of the grain.
To touch up noticeable scratches in the
stainless steel, sand very lightly with dry 100
grit emery paper in the direction of the grain.
Specks of grease can gather on the surfaces
of the stainless steel and bake on to the

GRILL RACK

The easiest way to clean the grill is
immediately after cooking is completed and
after turning off the flame. Wear a barbeque
mitt to protect your hand from the heat and
steam. Dip a brass bristle barbeque brush in
tap water and scrub the hot grill. Dip the
brush frequently in the bowl of water. Steam,

surface and give the appearance of rust.
For removal use an abrasive pad in
conjunction with a stainless steel cleaner.

control knob to “OFF”. If the smell of gas is
detected and the igniter is not functioning,
immediately turn the control knob
“OFF”.Allow 5 minutes for any accumulated
gas to dissipate. If the side burner igniter is not