Nexgrill 720-0133-LP User Manual

Page 19

OPERATING INSTRUCTIONS

GENERAL USE OF THE GRILL

Each main burner is rated at 12,000 Btu/hr.
The main grill burners encompass the entire
cooking area and are side ported to minimize
blockage from falling grease and debris.
Above the burners are stainless steel radiants
(flame covers). The igniter knobs are located
on the lower center portion of the valve panel.
Each rotary igniter is labeled on the control
panel.

USING THE GRILL

Grilling requires high heat for searing and
proper browning. Most foods are cooked at
the “HI” heat setting for the entire cooking
time. However, when grilling large pieces of
meat or poultry, it may be necessary to turn

the heat to a lower setting after the initial
browning. This cooks the food through without
burning the outside. Foods cooked for a long
time or foods basted with a sugary marinade
may need a lower heat setting near the end of
the cooking time.

NOTE: This stainless steel grill is designed to
grill efficiently without the use of lava rocks or
briquettes of any kind. Heat is radiated by the
stainless steel flame tamers positioned above
each burner.

NOTE: The hot grill sears the food, sealing in
the juices. The longer the preheat, the faster the
meat browns and the darker the grill marks.

DO NOT LEAVE THE GRILL
UNATTENDED WHILE COOKING.

connections with a soap and water solution
before operating the grill.

TO LIGHT THE GRILL BURNER:

Make sure all knobs are “OFF” then turn on the
gas supply from the LP tank. Always keep your
face and body as far from the grill as possible
when lighting.

If the burner does not light in 4 seconds ,turn
off the gas ,wait 5 minutes for any excess gas to
dissipate and then retry.

WARNING: IMPORTANT!

BEFORE LIGHTING…

Inspect the gas supply hose prior to turning
the gas “ON”. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to
use. Do not use the grill if the odor of gas is
present. Only the pressure regulator and hose
assembly supplied with the unit should be
used. Never substitute regulators for those
supplied with the grill. If a replacement is
necessary, contact the factory for proper
replacement.

Screw the regulator (type QCC1) onto the tank.
Leak check the hose and regulator

GRILL LIGHTING INSTRUCTIONS

Your stainless steel grill has a fully automatic
ignition to ignite each burner ,push on and
turn each burner slowly to high,the electronic
spark will repeatedly fine until the burner
ignites .