NEC N8406-022A - Manual (Page 81)

Command Line Interface 81
Operations Menu
Introduction
Operations-level commands are used for making immediate and temporary changes to switch configuration. The
Operations Menu is used for bringing ports temporarily in and out of service. This menu is available only from an
administrator and operator login.
Menu information
Command: /oper
[Operations Menu]
port - Operational Port Menu
passwd - Change current user password
clrlog - Clear syslog messages
tnetsshc – Close telnet/SSH connections
ntpreq - Send NTP request
The following table describes the Operations Menu options.
Table 83 Operations Menu options
Command Description
port <port number> Displays the Operational Port Menu.
passwd <1-128
characters> Allows the user to change the password. You need to enter the current password in
use for validation.
clrlog Clears all Syslog messages. This command is available only from an administrator
login.
tnetsshc Closes the telnet and SSH connections.
ntpreq Allows the user to send requests to the NTP server. This command is available
only from an administrator login.
Operations-level port options
Command: /oper/port <port number>
[Operations Port 1 Menu]
ena - Enable port
dis - Disable port
cur - Current port state
Operations-level port options are used for temporarily disabling or enabling a port.
Table 84 Operations-Level Port Menu options
Command Description
ena Temporarily enables the port. The port will be returned to its configured operation mode
when the switch is reset.
NOTE: This command does not enable a port that has been disabled by an ekeying mismatch error.
dis Temporarily disables the port. The port will be returned to its configured operation mode
when the switch is reset.
cur Displays the current settings for the port.