NordicTrack NTSY06990 - Manual (Page 9)

10. Remove the upper of the two 3/8Ó x 3Ó Bolts (45)
attaching the Top Frame (1) to the Main Upright (3).
Feed the bolt on the High Cable (73) through the indi-
cated slot in the Main Upright (3) in the direction
shown.
Note: Follow the procedure described in step 9
for attaching all Pulleys. Wrap the High Cable (73)
around a 4Ó Pulley (35) in the direction shown. Attach
the Pulley to the Main Upright (3) with a 3/8Ó x 2 1/2Ó
Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó
Pulley Bushings (42), and a 3/8Ó Nylon Jamnut (63).
Re-insert the 3/8Ó x 3Ó Bolt (45), and secure it with a
3/8Ó Nylon Locknut (50). Note: The Cable must be
seated in the groove of the Pulley before the Bolt
is attached.
10
12. Wrap the High Cable (73) around the remaining of
the two 4Ó Pulleys (35) in the direction shown.
Feed the bolt on the High Cable (73) through the indi-
cated slot in the Main Upright (3) in the direction
shown.
Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley to the Main Upright (3) with a 3/8Ó x
2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó
x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jamnut
(63).
11. Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley to the Left and Right Press Arms
(46, 82) with a 3/8Ó x 8 1/2Ó Bolt (59), and a 3/8Ó
Nylon Locknut (50).
12
9
Bolt
Slot
35
73
55
54
42
55
3
42
63
Bolt
Slot
35
73
55
54
42
55
3
82
46
42
63
45
50
1
11
50
73
35
46
82
59