Napoleon Fireplaces BGD42P - Manual (Page 21)

21
W415-0381 / H / 12.07.07
Remove the backing of
the logo supplied and
place on the glass view-
ing door, as indicated.
FIGURE 40
LOGO
½"
½"
LOGO PLACEMENT
PORCELAIN REFLECTIVE PANELS
1. Remove the upper louvres, and open the glass door. Remove
the logs.
2. Remove the two securing screws located on either fi rebox side.
3. Place the left panel against the left side
of the fi rebox, ensuring that it butts up to
the rear panel. Secure in place using 2 of
the screws previously removed. Repeat for
the right side.
4. Replace the logs, glass door and lou-
vres.
FIGURE 41
GRATE INSTALLATION
The grate for this fi replace has been removed for shipping pur-
poses.
The grate must be installed before the logs are installed.
Remove the packaging from the grate and install onto the two pins
as illustrated.
FIGURE 42
LOG PLACEMENT
PHAZER TM logs and glowing embers, exclusive to Napoleon® Fire-
places, provide a unique and realistic glowing effect that is different
in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect. Log colours may vary. During
the initial use of the fi replace, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.
1. Place the cutout in the bottom of log (W135-0297) behind the pilot
assembly. Rest the log against the back wall of the fi rebox.
2. Move the two small logs (W135-0298 & W135-0299) into posi-
tion, lining up the studs located on the burner with the holes on the
bottom of the logs.
3. Tear the glowing embers into pieces and place along the front row
of ports covering all of the burner area in front of the small logs. Care
should be taken to shred the embers into thin, small irregular pieces
as only the exposed edges of the fi bre hairs will glow. The ember
material will only glow when exposed to direct fl ame; however, care
should be taken to not block the burner ports. Blocked burner ports
can cause an incorrect fl ame pattern, carbon deposits and delayed
ignition. PHAZERtm logs glow when exposed to direct fl ame.
4. Place the bottom of the left crossover log (W135-0300) onto the
stud on the left side of the log support. The top of the log
should rest in the pocket on the back log.
GLOWING EMBERS
FIGURES 43a-e