Nortel Networks NN-10300-014 - Manual (Page 25)

Connect the IP Audio Conference Phone 2033 components
25
2. Connect one end of the AC power adapter cord to the power supply
port located on the back of the PIM. Thread the cord through the
channel on the bottom of the PIM and plug the other end into the AC
power source.
3. The middle port of the PIM (see Figure 5 on page 24) has an
attached CAT5 Ethernet cable. Thread the cord through the channel
on the bottom of the telephone and plug it into the PIM port on the
telephone.
See Figure 6 .
Figure 6: IP Audio Conference Phone 2033 connections
4. To connect an extension microphone, run the microphone cord
through one of the side channels on the bottom of the main unit, and
plug it into one of the extension microphone jacks. See
Figure 6 .
Note: A maximum of two extension microphone jacks are supported.