NISSAN 2008 Armada - Manual (Page 6)

3
It is also possible to change the default settings of
the Intelligent Key unlock/lock by using the Comfort &
Convenience mode under Settings in the control panel.
STARTING THE ENGINE

Push the ignition knob in.
 Confirm KEy DETECTED appears in the Vehicle Information Display.
 Turn the ignition knob to start the engine.
TURNING THE ENGINE OFF

Shift the transmission into P (Park).
 Turn the ignition knob to the LOCK position.
 An audible warning chime will sound when exiting the vehicle if the ignition knob is
not completely turned to the OFF position.
WINDSHIELD WIPER/WASHER SWITCH
 The ignition switch must be in the ON position
to activate the windshield wipers.
 Move the lever to the following positions to
operate the windshield wipers:
1 A Intermittent (INT) – Front wipers operate
intermittently and can be further adjusted
by twisting the time control ring
1 b
.
02
Low Speed (LO) – Continuous low-speed
operation of front wipers.
03
High Speed (HI) – Continuous high-speed
operation of front wipers.
04
Mist (MIST) – Lift the lever up for one sweep of the front wipers.
05
Rear Wipers (REAR) – Twist the end section to operate the first (INT) or second
(ON) speed settings for the rear wipers.
 The washer function activates the washer fluid and several sweeps of the wipers:
• For FRONT WASHER, pull lever toward you.
• For REAR WIPER, push lever away from you.
1 A
02
03
04
05
1 b