NISSAN 2008 Armada User Manual

Page 21

THIRD ROW POWER FOLDINg SEATS (if so equipped)
The third row folding seat controls are located on the second

row passenger (right-hand) side cupholder console and on the

passenger (right-hand) rear quarter trim panel area (behind third

row seating).
The left-side switch controls the driver side third row bench seat. The

right-side switch controls the passenger-side third row bench seat.
The power folding seats only operate when the transmission is in the P (Park) or N

(Neutral) position.
To fold down the third row seats using the power folding seat switch, press the down

portion

of the switch.

To return the seats to normal upright positioning, press the up portion

of the switch.

A warning beep will sound 5 times if the seat isn’t in the full upright or folded position when

the ignition is turned to the ON position.

HOMELINk

uNIVERSAL TRANSCEIVER (if so equipped)

SYSTEM OPERATING TIPS


Garage doors, electrical gates, entry doors, etc. will be activated during programming.

To avoid injury, make sure that people and objects are clear of all doors or gates

during programming. your vehicle’s engine should be turned off while programming

the HomeLink

Transceiver. Refer to your Owner’s Manual for complete details.



To program your HomeLink

Transceiver to operate a garage door, gate, or entry door

opener, home or office lighting, you need to be at the same location as the device.

TIP uP FOR EASY ENTRY TO THE 3RD ROW


The 2nd row outboard seats can be tipped forward for easy entry or exit from the 3rd
row bench seat. To enter the 3rd row, lift up on the latch

located on the upper

corner of the seatback on the 2nd row outboard seats and fold the seatback forward
at an angle at the seat base. This will release the back of the seat so it may be tipped
forward.



Then lift up on the lower corner of the seat base and tip the 2nd row outboard seat

forward. To exit the 3rd row bench seat, lift up on the same latch and fold the
seatback forward onto the seat base. Then, lift up on the seat base and tip it forward.

FOLDINg THE 3RD ROW SPLIT bENCH SEAT


To fold the seats flat, disconnect and secure the

center seat belt and tongues from the retractor

base. Then pull up on the latch

located on

the outside corner of each seatback and fold the

seatback forward over the seat base.



To raise the seats, lift the seatbacks and make sure

they are fully latched in the upright position.